Table of Contents
Advertisement
PERMA•LOCK™ HARDWARE (not to scale)
Uplight Lightbulbs S-11 25-watts (4)
IMPORTANT SAFETY INFORMATION:
Before starting the installation of your ceiling
fan, install the threaded downrod into the motor
coupling and lock the assembly.
Prepare for fan installation as follows:
Step 6a. Remove the paper shield from the motor.
Step 6b. Using the provided Allen wrench (attached to the
paper motor warning shield), loosen the Allen set screw.
Step 6c. Route the wires through the Perma•Lock™
downrod and ball assembly. Insert the downrod into the
motor coupling and turn it clockwise until it stops turning,
ensuring that the pole has bottomed out.
TIP: Th e downrod has a tapered thread that is designed
to lock completely when installed correctly.
Step 6d. Tighten the set screw with the Allen wrench to
ensure safe operation of your fan. If it is tight enough, you
should not be able to turn the downrod counterclockwise
with your hands. If in doubt, tighten the set screw with the
Allen wrench until you cannot turn it any further.
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod and
fall during normal operation.
Install Incandescent Lightbulbs
Step 7. Screw in four 25-watt incandescent lightbulbs as
shown.
NOTE: When replacing lightbulbs, be sure to use only
25-watt maximum.
FAN PREPARATION
Allen Wrench
Motor Wires
(leave at least 6" long)
Allen Wrench
Allen
Set Screw
Caution Shield
H
AMPSHIRE
3" Perma•Lock™ Downrod
and Ball Assembly
Ground Wire
Perma•Lock™ Downrod
and Ball Assembly
Tapered Thread
DANGER
IT IS IMPERITIVE THAT THE LOCKSCREW
BE SET TIGHTLY AGAINST THE DOWNROD
THREADS AFTER FAN IS ASSEMBLED
FAILURE TO DO SO WILL CAUSE FAN TO FALL
DO NOT OIL SEALED BEARINGS!
INSTALLER
INSTALLER
GIVE THIS TAG TO THE
CONFIRM LOCKSCREW
CONSUMER AFTER
IS PROPERLY TIGHTENED
INSTALLATION COMPLETE
P/N 1942640 SRB4/96
TIGHTEN
TIGHTEN
LOCKSCREW
LOCKSCREW
CAUTION
DAMP LOCATION RATED FANS
REQUIRE A GROUND FAULT INTERRUPTER (GFI)
USE A WEATHER PROOF OUTLET BOX
PROPERLY CONNECT GROUND WIRES
USE ONLY UNDER A WEATHER
PROOF STRUCTURE
™
(green)
Motor
Coupling
Motor Housing
Assembly
7
Advertisement
Table of Contents
