Installation & Wiring; Hanging The Fan - Casablanca Nouvelle Owner's Manual

N
DOWNROD & MOTOR COVER INSTALLATION
Preparation Step B. Route the black and white
wires from the motor through the downrod and
ball assembly. Make certain that you do not
scrape the insulation.
Preparation Step C. Using the provided allen
wrench, unscrew the allen set screw until it clears
the inside of the motor coupling. Screw the
downrod into the motor coupling until tight.
CAUTION: Failure to properly tighten the
downrod could result in the fan falling.
Preparation Step D. Using the provided allen
wrench, tighten the allen set screw to ensure
safe operation of your fan.
CAUTION: Failure to properly tighten
the downrod in the motor coupling and
securely tightening the locking bolt
could result in the fan falling during
normal operation!
Preparation Step E. Align the motor cover to
allow the four 8-32 X 3 (4) Phillips counter-
/
8
sunk screws to be installed.
Hand tighten securely
Step 5. To hang the fan body in the canopy,
hold the fan body firmly and insert the nylon
ball into the canopy opening. Check that no
wires were pinched. Rotate the fan body until
the slot in the nylon ball engages the canopy
pin opposite the canopy hatch opening.
6
™
OUVELLE
COUNTERSUNK

HANGING THE FAN

MOTOR WIRES
&
DOWNROD
GROUND
MOTOR
WIRES
DOWNROD
&
BALL
ASSEMBLY
PHILLIPS
SCREW
ALLEN SET SCREW
HOUSE WIRING
&
CROSSBAR
GROUND
BALL
GROUND
WIRE
MOTOR
COVER
TAPERED
THREAD
COUPLING
CANOPY
SLOT
PIN
MOTOR
CANOPY