Installation Instructions; Fan Preparation; Ceiling Hardware - Casablanca Metropolitan Owner's Manual

Hide thumbs Also See for Metropolitan:

Owner's manual (19 pages)

Owner's manual (19 pages)

Owner's manual (14 pages)

Table Of Contents

Table of Contents

unpacking: before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check

them against the parts listed here. before discarding packaging material, be certain that all parts have been removed.

AllEn SET

SCREw

¼-20 x ¼"

(PRe-INSTALLed)

ImPORTANT SAFeTY INFORmATION!

beFORe STARTINg THe INSTALLATION OF YOuR CeILINg FAN,

InSTAll ThE ThREADED DownRoD InTo ThE moToR CoUplIng

AnD loCK ThE ASSEmBly

Prepare for fan installation as follows:

Step A. Route the wires from the motor through the

Perma•Lock™ downrod and ball assembly.

Tip: The downrod has a tapered

thread that is designed to lock com-

pletely when correctly installed.

Step b. using the provided allen wrench, loosen the set

screw several turns to allow installation of the downrod.

Thread the downrod into the motor coupling until it stops

turning, this will take at least four and a half full turns.

Step C. Securely tighten the set screw with the provided

allen wrench to ensure safe operation of your fan.

CAuTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

CRoSSBAR

moUnTIng

BRACKET

Installing a New Ceiling Fixture Outlet box

If you do not have an existing fixture located where you

wish to place your Casablanca fan, an approved ceiling

fixture outlet box must be installed and wired.

Warning: To reduce the risk of fire, electrical

shock, or personal injury, mount to outlet box

marked acceptable for ceiling fan support.