Table of Contents
Advertisement
MOUNTING BRACKET INSTALLATION (CONT.)
Step 1. Place a flat washer on each of the two
screws that came with the outlet box and pass the
screws through the slotted holes in the ceiling plate
into the screw holes in the outlet box.
Step 2. Tighten the screws into the outlet box;
do not use lubricants on the screws. Do not over
tighten.
Step 3. Install the lag screw if needed pass the lag
screw with the large washer attached through the
center hole of the ceiling plate and screw into the
guide hole. Tighten until the outlet box is mounted
firmly to the beam. This box must be secured to the
ceiling firmly.
10
10
10
Ceiling Fan
Approved
Wiring Box
Joist
Washer
Outlet
Box
Screw
Ceiling Fan
Approved
Wiring Box
Joist
Washer
Outlet
Box
Screw
Lag Bolt
CANOPY HARDWARE
Canopy Screws and (4) Lock
Canopy
Canopy
Hatch
CANOPY INSTALLATION
Step 1. Attach the canopy to the ceiling plate with
three of the 8-32 x 2
/
" long canopy screws and
1
2
lock washers provided with your Casablanca fan.
Tighten using the provided screwdriver until snug
against the ceiling.
NOTE: On sloped ceilings, align the canopy
opening with the top or peak of the room.
FAN PREPARATION
Hanging Adapter
Perma•Lock™ Downrod
Cover
and Ball Assembly
FAN PREPARATION
Prepare for fan installation as follows:
Step 1. Remove the paper shield from the motor
as shown in Figure #1.
Step 2. Using the provided Allen wrench (attached
to the paper motor shield), loosen the Allen set
screw making sure that end of the Set Screw can
not be seen within the motor coupling as shown
in Figure #2. If so, you will need to unscrew the
Set Screw so that the tip of the Set Screw does not
remain in the path of the downrod.
A
A
cAdemy
cAdemy
Phillips
Washers
Screwdriver
Canopy
Lock
Washer
Canopy
Screw
Canopy Cover
Allen Wrench
Ring
PAPER MOTOR
SHIELD
FIGURE 1.
Set Screw
FIGURE 2.
11
11
11
Hide quick links:
Advertisement
Table of Contents
