Setting Up Routing Options - ADTRAN TOTAL ACCESS 600R User Interface Manual

Setting up Routing Options

The Total Access 600R can support IP routing and bridging.These procedures are described on the pages that follow.
IP Routing
There are three steps required for the Total Access 600R to be used for IP Routing: (1) Global IP Setup, (2) Ethernet
IP Setup, and (3) WAN IP Setup. All of these procedures are described in the pages that follow.
Global IP Setup
For basic IP routing, use all of the default values from the
Step
1
2
3
4
5
6
7
64200600L1#T-31A
Global IP Setup Instructions
From the Main Menu, select R
G .
LOBAL
Press Enter on the IP [+] option.
Set the M to O .
ODE N
Press Enter on the S
TATIC
ing table.
Press Enter on DHCP S
ERVER
serve IP addresses to Ethernet devices.
Set the DHCP M to O
ODE N
To place DNS information in the Total Access 600R, press Enter on
DNS [+]. Enter Server IP addresses in the server fields.
© 2002, ADTRAN, Inc.
Total Access 600R User Interface Guide (UIG)
configuration menu.
G
LOBAL
Action
, select C , and then select
OUTER ONFIG
R [+] to place static routes in the rout-
OUTES
[+] if the Total Access 600R needs to
. It is O by default.
FF
Page 67