Initial Setup - ADTRAN TOTAL ACCESS 600R User Interface Manual

Total Access 600R User Interface Guide (UIG)
Appendix A. Configuring the Total Access 600R for Routing

Initial Setup

Before the Total Access 600R can be configured for routing, DS0s must be mapped. (See DS0 Mapping below.)
DS0 Mapping
Step
1
2
3
4
5
6
7
Page 66
DS0 Mapping Instructions
From the Main menu, select C
Verify that the A M
CTIVE AP
map that is actively running on the Total Access 600R. The unit has the
ability to store two maps.
• To edit the current map, press Enter on M
(If Map 1 is the Active Map)
• To edit the standby map, press Enter on M
(If Map 1 is the Active Map)
The T1 line entering the Total Access 600R is broken up into 24 DS0s
or channels. At least one DS0 needs to be mapped to the router in
order to use the unit for routing purposes.
Scroll down to the DS0 that will be mapped. (Any DS0 can be mapped
to the router.)
Set the S number of the DS0 that you are mapping to RCU:TA600.
LOT
Set the P of the DS0 that you are mapping to R
ORT
56K, depending on the line speed.
ER
Map all the DS0s as desired, and exit this menu by pressing the left ar-
row button. Your changes will automatically save when exiting the map.
Make sure the A M
CTIVE AP
running) before exiting the M
© 2002, ADTRAN, Inc.
Action
B and then select DS0 M
HANNEL ANK
is set to either M 1 or M
AP
1 [+] to view the map.
AP
2 [+] to view the map.
AP
OUTER
is set to the correct map (the map you want
/DS0 M menu.
ODULES APS
.
APS
2. This is the
AP
64K or R -
OUT
64200600L1#T-31A