ADTRAN TOTAL ACCESS 600R User Interface Manual page 44

Total Access 600R User Interface Guide (UIG)
NAPT A
E
NTRY
E
NTRY
C
OUNT
R
OUTE
The IP parameters are configured in this menu. For unnumbered interfaces, the Total Access 600R
will automatically discover the PPP peer's networks using PPP IPCP and/or RIP.
F
AR
N
ETMASK
S
TATIC
P
RIVATE
H
OPS
F
ORCE
L
OCAL
RIP
Use this menu to enable RIP on the WAN interface.
Page 44
S P This option is only available when
ERVER ORT
enabled. This is the port used on the public side.
T This option is only available when
IME
enabled. This is the time since the entry was last used.
I C This option is only available when
N NT
enabled. This is the number of packets that came in.
O C This option is only available when
UT NT
enabled. This is the number of packets sent out.
This option is only available when
DDRESS
enabled. Represents the public address that is being used as the
NAPT address. Read-only.
C This option is only available when
OUNT
enabled. The number of entries in the NAT table. Maximum is
1500.
O This option is only available when
VERFLOW
enabled. A count of the dropped entries due to entry count being
1500 or greater; i.e., the NAT table is full.
-E IP/NET The PPP peer's IP address or network can be set here, if known.
ND
Leaving this at 0.0.0.0 means that the Total Access 600R will de-
termine the PPP peer's IP and network (if unnumbered) using
the PPP IPCP. Default is
This network mask is applied to the IP/NET address for
determining the PPP peer's network. If left as 0.0.0.0, a
standard network mask is used. Default is 0.0.0.0.
R
OUTE Selecting Y
the route table. Default is Y
Selecting Y
tised. Default is N
(1-16)
This value is the metric or number of hops that RIP will
use in advertising the static route. The range is 1 to 16,
where 1 is the default. The value 16 is considered an infi-
nite distance in RIP and is, in effect, poisoning the route.
IP
When set to Y
the IP address in the IP/Net for this profile as its WAN IP
address. Normally this is set in the N
N .
O
IP
This is the IP address that is assigned to the PPP link when
using numbered links. By default, no address is assigned
and the PPP link is unnumbered. Default is 0.0.0.0.
© 2002, ADTRAN, Inc.
NAT P
NAT P
NAT P
NAT P
NAT P
NAT P
NAT P
0.0.0.0
.
will add a static route to the remote peer to
ES
.
ES
will prevent this route from being adver-
ES
.
O
, the 600R will force the PPP peer to use
ES
is
T
ORT RANSLATION
is
T
ORT RANSLATION
is
T
ORT RANSLATION
is
T
ORT RANSLATION
is
T
ORT RANSLATION
is
T
ORT RANSLATION
is
T
ORT RANSLATION
position. Default is
O
64200600L1#T-31A