Router>Status; Figure 10. Router/Status Menu - ADTRAN TOTAL ACCESS 600R User Interface Manual

Total Access 600R User Interface Guide (UIG)
O PVC
UT TO
The packets which transmit out this PVC from the Total Access 600R can be filtered in three ways:
D
ISABLE
B
LOCK
F
ORWARD
O E
UT XCEPTIONS
This is a list of up to 32 filter entries. The setup is exactly the same as the F
list.
Maintenance DLCI
The Total Access 600R can be configured from the WAN without having to preset a DLCI mapping or
IP address. This value is the DLCI number used to open an IP session by the Total Access 600R. Any IP
packet arriving from the PVC is assumed to be for the Total Access 600R's IP stack. The destination
address in the packet is assigned as the PVC's local IP address. The source address is used to add a host
route in the routing table. The default is 901, but any legal DLCI number can be used.
BECN Timeout (msec)
This value is expressed in milliseconds and represents the amount of time the Total Access 600R will
stop transmitting over a PVC which received a packet with the BECN bit set. The default is 1.5 seconds.
R >S
OUTER TATUS
Use the R
/S
OUTER TATUS
give the user useful information for debugging the current routes in the 600R.
Page 54
(D ) Turns off packet output filtering. No outgoing packets to this
EF
PVC are blocked.
All outgoing packets to this PVC are blocked except as defined
A
LL
in the F
A All outgoing packets to this PVC are not blocked except as de-
LL
fined in the F
menu to view and set the parameters shown in Figure 10. The R

Figure 10. Router/Status Menu

© 2002, ADTRAN, Inc.
/O E
ILTERS UT XCEPTIONS
/O E
ILTERS UT XCEPTIONS
list.
list.
/I E
ILTER N XCEPTIONS
screens
/S
OUTER TATUS
64200600L1#T-31A