ADTRAN TOTAL ACCESS 600R User Interface Manual page 37

IP F
ILTER
The IP filter defines apply to any IP packet, whether it is routed or bridged. Up to 32 IP defines can
be specified.
N
AME
S
RC
S
RC
D
EST
D
EST
S
RC
S
RC
D
EST
D
EST
P
ROTO
P
ROTO
64200600L1#T-31A
D
EFINES
Identifies the filter entry. Default is no entry in name field.
A IP address compared to the source address (dotted decimal
DDR
format) Default is
M Bits which are used in the source comparison. (dotted deci-
ASK
mal format) Default is
A IP address compared to the destination address (dotted dec-
DDRESS
imal format). Default is
M Bits which are used in the destination comparison. (dotted
ASK
decimal format) Default is
P IP source port number used for comparison Range: 0 to
ORT
65535. (decimal format) Default is
P C Type of comparison that is performed. Default is none.
ORT OMP
P IP destination port number used for comparison Range: 0
ORT
to 65535. (decimal format) Default is
P C Type of comparison that is performed. Default is none.
ORT OMP
P Protocol used for comparison. Range: 0 to 255. (decimal
ORT
format) Default is
P C Type of comparison that is performed. Default is none.
ORT OMP
© 2002, ADTRAN, Inc.
Total Access 600R User Interface Guide (UIG)
0.0.0.0.
0.0.0.0.
0.0.0.0.
0.0.0.0.
= means ports equal to
not = means port not equal to
> means port greater than
< means port less than
None - means the source port is not compared
= means ports equal to
not = means port not equal to
> means port greater than
< means port less than
None - means the destination port is not compared
0.
= means protocols equal to
not = means protocols not equal to
> means protocols greater than
< means protocols less than
None means the protocol is not compared
0.
0.
Page 37