Total Access 600R User Interface Guide (UIG)
S
C
YSTEM
ONFIG
This is the far-end IP address used for FDL management. The FDL is a separate IP network from the
customer data that is configured under the
S
C
YSTEM
ONFIG
This is the subnet mask defining the IP network used for FDL management. The factory default is
0.0.0.0
.
S
C
YSTEM
ONFIG
When set to
address. A 255.255.255.252 netmask is used, which determines the far-side address as well (since there
can be only two addresses on a subnet with that netmask). When set to
address assigned to the FDL interface. Default is
S
C
YSTEM
ONFIG
When set to
munity table. When set to
SNMP traffic is rejected if a match is not found. Default is
S
C
>M
YSTEM
ONFIG
AINT
S
C
>M
YSTEM
ONFIG
AINT
The Total Access 600R's VT 100
unit. The setup for this port is under this menu.
When
P
P
ASSWORD
ROTECT
prompt for a password upon startup.
S
C
>M
YSTEM
ONFIG
AINT
This is the text string that is used for comparison when password protecting the maintenance port. By default, no pass-
word is entered. You can enter up to 15 characters in this field.
The security level for the maintenance port is always set to 0. This gives full access to all menus.
Passwords are case-sensitive.
Page 26
>SNMP M
>FDL>F
ENU
>SNMP M
>FDL>IP N
ENU
>SNMP M
>FDL>L
ENU
, the destination address on each received packet is assumed to be the FDL interface
O
N
>SNMP M
>FDL>A
ENU
, SNMP gets/sets received over the FDL link are always accepted regardless of the com-
O
N
, the community table is searched for valid manager IP addresses and the
O
FF
P
M
ORT
ENU
P
M
>P
ORT
ENU
ASSWORD
port can be accessed through a RJ-48 connector located on the rear of the
CRAFT
is set to
, the maintenance port is not password protected. When
N
O
P
M
>P
ORT
ENU
ASSWORD
© 2002, ADTRAN, Inc.
E
IP A
AR
ND
DDRESS
menus. The factory default is
R
OUTER
ETMASK
A
EARN
DDRESS
.
O
N
A
SNMP
CCEPT
LL
.
O
N
P
ROTECT
0.0.0.0
.
, the user must input the IP
O
FF
(def), the 600R will
Y
ES
64200600L1#T-31A
Need help?
Do you have a question about the TOTAL ACCESS 600R and is the answer not in the manual?