Download  Print this page

Attaching The Walking Foot - Brother NC21SE Operation Manual

Computerized sewing and embroidery machine.
Hide thumbs

Advertisement

Table of Contents
CHANGING THE PRESSER FOOT

Attaching the Walking Foot

The walking foot holds the fabric between the
presser foot and the feed dogs to feed the fabric.
This enables you to have better fabric control
when sewing difficult fabrics (such as quilting or
velvet) or fabrics that slip easily (such as vinyl
cloth, leather, or synthetic leather).
Note
• When sewing with the walking foot, sew at
medium to low speeds.
Memo
• The walking foot can only be used with
straight or zigzag stitch patterns. Reverse
stitches cannot be sewn with the walking
foot. Only select straight or zigzag stitch pat-
terns with reinforcement stitches.
a
a
a
a
Follow the steps in "Removing the Presser
Foot" on the previous page.
b
b
b
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
c
c
c
c
Set the operation lever of the walking foot
so that the needle clamp screw is set
between the fork, and position the walking
foot on the presser foot bar.
a Operation lever
b Needle clamp screw
c Fork
d Presser foot bar
38
b
a c
d
d
d
d
d
Lower the presser foot lever. Insert the
screw, and tighten the screw securely with
the screwdriver.
CAUTION
• Use the included screwdriver to tighten the
screw securely. If the screw is loose, the
needle may strike the presser foot and cause
injury.
• Be sure to turn the handwheel toward the
front of the machine to check that the needle
does not strike the presser foot. If the needle
strikes the presser foot, injury may result.

Advertisement

Table of Contents

   Also See for Brother NC21SE

   Related Manuals for Brother NC21SE

Comments to this Manuals

Symbols: 0
Latest comments: