Setting The Bobbin - Brother NC21SE Operation Manual

LOWER THREADING
d d d d
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
e e e e
Holding the thread with your hands, slide
the thread into the grooves on the thread
guide plate.
a
a Thread guide plate
f f f f
Pass the thread through the thread guide.
a Thread guide
g g g g
Pass the thread under the pin. Then pass the
thread around the pretension disk making
sure that the thread is under the pretension
disk.
b
c
a Thread guide
b Pin
c Pretension disk
h h h h
Follow steps
through 25.
26
a
a
g g g g j j j j
through on page 24

Setting the Bobbin

→
Press
in that order to display a video example of
the operation on the LCD (see page 22). Follow
the steps explained below to complete the
operation.
CAUTION
• Use a bobbin thread that has been correctly
wound. Otherwise, the needle may break or
the thread tension will be incorrect.
• The enclosed bobbin was designed specifically
for this sewing machine. If bobbins from other
models are used, the machine will not operate
correctly. Use only the enclosed bobbin or
bobbins of the same type (part code: SA156,
(XA5539-151)).
11.5 mm
(approx.
7/16 inch)
This model
Before inserting or changing the bobbin,
•
be sure to press
otherwise injuries may occur if the "Start/
Stop" button or any other button is
pressed and the machine starts sewing.
a a
a a
Press the "Presser Foot Lifter" button to
raise the presser foot.
→ →
Actual size
Other models
in the LCD,