Kessel Pumpfix F Comfort Instructions For Assembly, Operation And Maintenance page 31

Display
4. Operating the Comfort control unit
Description
It shows 15 Parameters
Switch-on delay after power failure
Not occupied
Switch-on delay for the motor-driven
flap is displayed
Not occupied
The maximum flap cycles are dis-
played
The maximum power consumption
value of the motor is displayed
Information
1.5.1 Mains switch-on delay
1.5.2 Switch-on block
1.5.3 Switch-on delay 1
1.5.4 Run-on time 1
1.5.5 Max. cycles flap 1
1.5.6 Max. current flap 1
1.5.7 Transmitting figure
1.5.8 System diagnosis SDS
Default value is 2 sec.
Not occupied
Default value is 2 sec.
Not occupied
Default value is 5000 closing procedures.
Then alarm message "Replace motor"
31
1.5.9 Operating mode
1.5.10 Switch-on delay 2
1.5.11 Run-on time 2
1.5.12 Max. cycles PU
1.5.13 Max. current PU
1.5.14 Min. current PU
1.5.15 Running time limit