Wastewater lifting station for installation in a concrete slab/floor for wastewater with and without raw sewage, single/twin pump (104 pages)
Summary of Contents for Kessel Pumpfix F Comfort
Page 1
INSTRUCTIONS FOR ASSEMBLY, OPERATION AND MAINTENANCE KESSEL - backwater pumping station for wastewater with and without sewage Pumpfix ® F Standard/Comfort Product advantages For wastewater with and without sewage Backwater flap and draining pump Simple installation in through pipes Plug & play control unit...
Table of contents ......................Page 1. Safety instructions Use ..................... Page Scope of supply.................. Page 2. General points Installation procedure ................. Page General instructions about the installation of backwater valves ..Page Installation in the ground plate............Page Recessed installation in the ground plate........... Page 3.
2. General a free-standing device in order to prevent The KESSEL backwater pumping station The scope of supply of the KESSEL back- soiling of the system. 2.1 Use 2.2 Scope of supply Pumpfix F has been designed for through water pumping station Pumpfix F is ®...
Page 4
(at least DN 50, height. Kessel recommends 2 x 45° bends) must be b) Laying the tiles e.g. using PCI Silcoferm S provided. A second probe cable and motor (self-adhesive silicone).
4. Service and maintenance Standard Comfort 4.1 Service The system must be checked once every month by the operator through observati- on of the switching routine for operational ability and leaks. • Close emergency valve or with Komfort: press test key to carry out functional test on backwater valve ->...
4. Service and maintenance 4.4 Pump removal: The pump can be removed individually. To do this, turn both pump removal levers through 180°. This makes them fold out- wards to the side so that the pump can be lifted out. Fig.
4. Service and maintenance 4.7 How the emergency valve works 4.7.1 Standard Locking position (Fig. 17, emergency valve completely closed): The hand lever of the emergency valve must be put in the respective CLOSED position. The back- water flap works as a pipe barrier. This function is only considered as protection from backwater during longer periods of Fig.
5. Spare parts 5.1 Standard F for installation in an exposed wastewater pipe Pumpfix ® All spare parts can be purchased from a specialist company. F -control unit Standard IP 54 28073 Pumpfix Designation Art. no. a,b,c ® a) Additional board for potential-free contact 80072 b) Remove signal generator 20 m...
5. Spare parts 5.2 Comfort Pumpfix F for installation in an exposed wastewater pipe ® All spare parts can be purchased from a specialist company. F -control unit Komfort IP 54 28071 Pumpfix Designation Art. no. ® a) Additional board for potential-free contact 80072 ...
Page 11
6. Warranty 1. In the case that a KESSEL product is de- or part needing repair or replacement A requirement of this additional warranty fective, KESSEL has the option of repai- and not necessarily to the entire product is that the product is properly installed ring or replacing the product.
Page 12
__________________________________________________________ Planner __________________________________________________________ Address __________________________________________________________ Telephone / Fax __________________________________________________________ Contracted plumbing company __________________________________________________________ Address __________________________________________________________ Telephone / Fax __________________________________________________________ KESSEL-Commissions no.: System operator /owner __________________________________________________________ Address __________________________________________________________ Telephone / Fax __________________________________________________________ User __________________________________________________________ Address __________________________________________________________ Telephone / Fax __________________________________________________________ Person of delivery...
Page 14
8. Commissioning Protocol for installation company Handover certificate (copy for the company carrying out the installation) The initial operation and instruction was carried out in the presence of the person authorised to perform the ac- ceptance and the system operator. The system operator/person authorised to perform the acceptance was informed about the obligation to service the product according to the enclosed operating instructions.
Page 16
Backwater protection Septic Systems Lifting Stations and pumps Inspection Chambers Drains and shower channels Rainwater Management Systems Separators -Grease Separators -Oil-/ Fuel-/Coalescence Separators -Starch Separators -Sediment Separators...