Kohler 14RESA Manual page 141

Residential/commercial generator sets
Hide thumbs Also See for 14RESA:
Table of Contents

Advertisement

1
1. Alternator duct
Figure 7-35 Alternator Duct, RESA(L)/RESC(L)
16. Reinstall the enclosure panels in reverse order of
removal.
See Figure 7-36 and refer to the
disassembly instructions, if necessary.
a. Install the left side panel.
b. Install the exhaust end panel.
c. Install the front panel.
d. Install the right side panel.
e. Install the thermal cover shown in Figure 7-37.
Note: Do not overtighten the lock nuts. Verify that
the hinge bracket is allowed to pivot.
f. Install the front panel.
g. Install the generator set housing roof.
TP-6805 8/15
17. Re-apply the 120VAC power supply to the
generator set by closing the upstream circuit
breaker.
18. Turn on the fuel supply. Press RUN to start the
generator set and check for leaks with the engine
running.
19. Press OFF to turn off the generator set. Then press
AUTO if an automatic transfer switch or remote
start/stop switch is used.
20. Lower and secure the roof.
1
TP-6805
Right Side
1. Roof
2. Rear panel (exhaust end)
3. Left side panel
4. Front panel (air intake end)
5. Right side panel
Figure 7-36 Generator Set Enclosure, 14/20RESA(L)
2
3
5
or 20RESC(L)
Section 7 Disassembly/Reassembly
4
Front (air
intake end)
ADV7341
141

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

14resal20resa20resal20resb20resc20rescl ... Show all

Table of Contents