Kohler 14RESA Manual page 129

6. Remove two screws and remove the front panel.
See Figure 7-5.
1. Remove 2 screws
Figure 7-5 Front Panel (air intake end panel)
7. Unplug the carburetor heater (if equipped) from the
120 VAC receptacle.
8. Verify that utility power to the generator set terminal
block has been disconnected.
9. Disconnect the generator set engine starting
battery, negative (--) lead first.
10. Disconnect output leads or load circuit cables at the
field-connection terminal block.
11. Remove two nuts and lift off the exhaust end panel.
See Figure 7-6.
1. Remove 2 screws
Figure 7-6 Rear Panel (exhaust end panel)
TP-6805 8/15
1
GM72523
1
1
GM72523
12. From the inside of the enclosure, remove four nuts
securing the left side panel. See Figure 7-7.
13. Pull the panel up and off.
1
ADV-7876
2
1. Left side panel
2. Remove 4 nuts
Figure 7-7 Left Side Panel
Section 7 Disassembly/Reassembly
2
Note: Bulkhead design may
vary.
129