Kohler 14RESA Manual page 134

Note: Obtain new exhaust gaskets before removing the
muffler.
17. Disconnect the muffler from the engine at the two
flange connections and remove the muffler. See
Figure 7-20.
1
4
3
1. Exhaust flanges (qty. 2)
2. Muffler
3. Alternator vibromounts (qty. 2)
4. Engine vibromounts (qty. 2)
Figure 7-20 Muffler and Vibromounts
134 Section 7 Disassembly/Reassembly
7.2.3
18. Disconnect the following alternator wiring inside
the controller junction box.
diagrams in Section 8.
a. Disconnect lead 55 from the mini-breaker on
b. Disconnect P2 from the controller.
2
c. Disconnect leads 2 and 3 from neutral stud L0.
d. Disconnect leads 1 and 4 from the circuit
19. Remove the bolts securing the two alternator end
vibromounts to the skid. Loosen the two engine
vibromounts. See Figure 7-20.
20. Raise the alternator end of the generator set
enough to place a wood support beneath the rear of
the engine.
enough to span the opening in the base. See
Figure 7-21.
Note: Use a hoist or lifting device that is rated for
1. Engine support
Figure 7-21 Wood Support for Engine (RESA shown)
Generator Disassembly
the controller.
breaker.
The wood support must be long
the weight of the generator set.
Section 7.1.
See the wiring
See
1
img_0160
TP-6805 8/15