Kohler 14RESA Manual page 139

7. Reinstall the end bracket components.
a. Inspect the brushes. If brushes show uneven
wear or are worn to less than half their original
length, replace them. See Section 6.6.
b. Install the brush holder with shim onto the end
bracket. Verify that the brushes are not sticking
in the holder.
c. Verify that the brushes are centered on the slip
rings. If required, insert spacers between the
mounting surface and brush holder to center
the brushes on the slip rings. See Figure 7-33.
See Section
information.
d. Use the cable tie to secure the brush leads to
the end bracket.
Correct
1
3
Side View
1. Correctly positioned brush
2. Incorrectly positioned brush
3. Slip rings
Figure 7-32 Brush Position
TP-6805 8/15
6.6, Brushes, for
Incorrect
2
3
TP5867
3
more
4
1. Brush(es)
2. Brush holder
3. Slip rings
Figure 7-33 Brush Assembly (revised)
4
1
2
GM62996
5
Spring Not
Shown
1
1
4. Shim
5. Spring
Section 7 Disassembly/Reassembly
GM80980
2
GM80982
Length New
19.0 mm
(0.75 in.)
GM80981
139