Kohler 14RESA Manual page 140

7.3.2 Reassemble Exhaust System
8. Install the exhaust system. See Figure 7-34.
Note: Use new exhaust gaskets when re-installing
the muffler.
a. Install the heat shield onto the alternator
exhaust support.
b. Using new gaskets, connect the engine
exhaust muffler to the engine at the flanges. Do
not final tighten the mounting hardware.
c. Secure the muffler mounting tab to the heat
shield.
d. Torque the nuts securing the engine muffler
flange to the engine to 24 Nm (17.7 ft. lb.).
1
1. Exhaust flanges (qty. 2)
2. Muffler
3. Alternator vibromounts (qty. 2)
4. Engine vibromounts (qty. 2)
Figure 7-34 Exhaust System (RESA shown)
140 Section 7 Disassembly/Reassembly
2
3
4
TP-6805
7.3.3 Reinstall Enclosure,
14/20RESA(L) and 20RESC(L)
9. Reinstall the alternator duct panels shown in
Figure 7-35.
10. Reconnect the following alternator wiring inside the
controller junction box. See the wiring diagrams in
Section 8.
a. Reconnect lead 55 to the mini-breaker on the
controller.
b. Reconnect P2 to the controller.
c. Reconnect leads 2 and 3 to neutral stud L0.
d. Reconnect leads 1 and 4 to the circuit breaker.
e. Reconnect any other controller connections
that were removed during disassembly.
11. Press the OFF button on the generator set
controller.
Connecting the battery and the battery charger.
Hazardous voltage can cause severe injury or death.
Reconnect the battery correctly, positive to positive and
negative to negative, to avoid electrical shock and damage to
the battery charger and battery(ies).
electrician install the battery(ies).
12. Reconnect the generator set engine starting
battery, negative (--) lead last.
13. Reconnect the carburetor heater (if equipped) to
the 120VAC receptacle.
14. Reconnect the utility power to the generator set.
15. Reconnect output leads or load circuit cables at the
field-connection terminal block.
Have a qualified
TP-6805 8/15