10
Performing a Scan to Server (FTP) operation
This chapter provides descriptions of the procedures for sending scan data to servers.
10.1
Basic transmission
In order to perform a Scan to Server (FTP) operation, certain settings such as the FTP
server address must be specified in advance. These settings can be specified using
Easy Web Management. For details on Easy Web Management, refer to "Using Easy
Web Management" on page 11-1.
In addition, the FTP server address must be registered as a speed dial number. Refer
to "Registering speed dial destinations (FTP servers)" on page 8-14.
Note
Speed dial settings and settings the destination server address for Scan to Server
(FTP) operations can only be specified from Easy Web Management. These set-
tings cannot be specified from the control panel.
Using the automatic document feeder
1
Press the [Scan] key.
10-1