Canon MultiPASS L6000 User Manual page 199

Message
COMMUNICATING
PLEASE WAIT
DOC TOO LONG
DOCUMENT READY
ECM RX
ECM TX
HANG UP PHONE
LOAD PAPER
MEMORY FULL
MEMORY FULL
PLEASE WAIT
Chapter 10
Error Code Cause
— You tried to send a fax
manually when the
MultiPASS was already
sending a fax from
memory.
#003 It took more than 32
minutes to send or
copy a document.
It took more than 32
minutes to receive a
document.
The document is longer
than 39.4 inches (1 m).
— The document in the
ADF is ready for faxing,
scanning, or copying.
— The MultiPASS is
— receiving (RX) or
sending (TX) a fax
using ECM.
— The telephone is
off hook.
— The MultiPASS is out
of recording paper
(the multi-purpose
tray is empty).
#037 The memory of the
MultiPASS is full
because it has received
too many documents,
or a very long or
detailed document.
Memory is full because
you tried to send too
many pages at once,
or a very long or
detailed document.
— The MultiPASS is
sending a fax and its
memory is full.
Action
Wait until the fax is
sent, or use memory
sending.
Divide the document
and send or copy each
part separately.
Contact the other party.
Have them divide the
document and send
each part separately.
Use a copy machine to
make a reduced copy of
the document and send
the copy.
Send the fax, scan the
document, or make a
copy.
ECM transmissions may
take longer than normal
transmissions. Turn off
ECM if you need to
receive or send quickly,
or if you know your local
lines are in good
condition.
Place the telephone
properly into its cradle.
Load paper in the multi-
purpose tray. Any
documents received in
memory will be printed
automatically.
Print out any documents
that are stored in
memory. Then start the
operation again.
Divide the document
and send each part
separately.
The MultiPASS
continues to send the
fax as memory becomes
available.
Troubleshooting 10-13