Canon MultiPASS L6000 User Manual page 19

Place the MultiPASS on a sturdy level surface. Do not place it on an
unstable cart, stand, or table. If the unit falls, it could be seriously
damaged.
Do not use the MultiPASS near water. If you spill liquid on or into
the unit, unplug it immediately and call the Customer Care Center.
Slots and openings in the unit and on the back or bottom are provided
for ventilation. To ensure reliable operation of the MultiPASS and to
protect it from overheating, do not block or cover these openings. Do
not block the openings by placing the unit on a bed, sofa, rug, or other
similar surface. Do not place the unit near a radiator, nor in a closet or
built-in cabinet unless proper ventilation is provided.
Operate the MultiPASS only from the type of power source indicated
on the unit's label. If you are unsure of the type of power available,
consult your dealer or local power company.
Do not allow anything to rest on the power cord, and do not locate
the MultiPASS where the cord will be walked on. Make sure the power
cord is not knotted or kinked.
Do not push metal objects of any kind into the slots or openings on
the cabinet. This could result in a risk of fire or electric shock.
Do not allow small objects (such as pins, paper clips, or staples) to fall
into the MultiPASS. If something does fall into it that you cannot
remove, unplug the unit immediately and call the Customer Care
Center.
Unplug this product from the wall outlet and call the Customer Care
Center if any of the following conditions exist:
•
•
•
•
•
1-4 Introduction
The power cord or plug is damaged or frayed.
Liquid is spilled into the unit, or if the unit is exposed to rain
or water.
Smoke, unusual noises, or odors come from the unit.
The unit has been dropped or the cabinet has been damaged.
The unit does not operate normally when you have followed the
operating instructions. Adjust only those controls that are covered
by the operating instructions in the Quick Start Guide and this
User's Manual. Improper adjustment of other controls may result
in damage and may require extensive work by a qualified
technician to restore the product to normal operation.
Chapter 1