Canon MultiPASS C530 Software Manual page 294

Ring Time
When your MultiPASS is set to receive both fax and telephone calls, it rings to inform you
of an incoming telephone call. If you do not pick up the telephone receiver within a certain
amount of time, the MultiPASS stops ringing. You use this option to set the appropriate
amount of time the MultiPASS should ring.
Ring Tone
You can set the volume level of the ring tone.
Default Action If No Answer to Telephone
You set this option to Receive if you want the MultiPASS to handle an incoming call,
detected as a telephone call that is not answered, as an incoming fax. If no fax is received,
the line is then disconnected. If you set this option to Disconnect, the MultiPASS
automatically disconnects the unanswered call, without switching to try and receive a fax.
Enable Reception of Color Faxes
Select this option if you want your MultiPASS to receive color faxes. If this option is
cleared, the MultiPASS does not receive color faxes.
Manual/Auto Switch
To prevent missing incoming documents when the MultiPASS is set to manual receiving,
you can set the unit to automatically answer the phone and switch to automatic. The unit
can receive the incoming fax after the specified ring time (the number of seconds you
specify).
Chapter 6 Utilities
6-17