Pentair PROSTOP-E Installation And Operation Manual page 34

CONTROL OVERVIEW
DIAGNOSTIC 1
1
2
3
This tab contains a variety of information that is specific to
ProStop-E ISOBUS Rate Controller - Serial Number, Hours,etc
1. ECU Instance:
Leave this value at 0 unless there are multiple ECUs of
the same Device Class and Device Function on the bus.
Set ECU Instance to 1, if there is a conflict.
2. Device Class Instance:
Leave this value at 0 unless there are multiple ECUs
of the same Device Class on the bus. Set Device Class
Instance to 1, if there is a conflict.
3. Device Function Instance:
Leave this value at 0 unless there are multiple ECUs
of the same Device Class on the bus. Set Device Class
Instance to 1, if there is a conflict.
4. Home
Softkey navigates back to the Home screen.
5. Configure
Softkey navigates back to the Configure screen..
6. Disconnect
Softkey - disconnects the ProStop-E ISOBUS rate
controller from the ISOBUS network.
34
4
5
6
HYP1100 (04-08-21)