Pentair PROSTOP-E Installation And Operation Manual page 26

CONTROL OVERVIEW
SECTION CONFIGURATION
After defining the number of sections and touching "START" on the Actuator Auto Config. Softkey, each section should populate with
"1" nozzle to allow for individual nozzle control. Use the arrow at the bottom of the screen to review all assignments. If creating Virtual
Sections, enter the desired number of ProStop-E nozzles that will be in each section.
CANNODE CONFIGURATION
The cannodes must be organized to match the machine layout. Use the corresponding arrows to modify the cannode order. For
example: the leftmost cannode is position 1 and controls the leftmost nozzles, center cannode is position 2 and controls nozzles
in the center, and the rightmost cannode is postion 3, controlling the rightmost nozzles on the boom. If all of the cannodes on the
machine are not visible, press the "RESET CANNODES" softkey, and the cannodes will be reidentified.
HYP1100 (04-08-21)
26