Table of Contents
Advertisement
CONTROL OVERVIEW
CHANNEL SETUP - ISOBUS
1
2
3
4
5
6
7
8
9
Note: Fields 1, 7, 8, 9 on this screen may not be modified when connected to the Task Controller.
1.
Enable Prescription Control
Enables prescription control for system use with
prescription field maps. Default should be unchecked.
2.
Look Ahead Times
These controls allow the system to anticipate controller
activity to effectively account for the time it takes the
task controller to send, and the ProStop-E ISOBUS rate
controller to respond to control commands.
3.
Rate Change
This setting is the number of seconds that the system will
anticipate application rate control activity . Default is 0
(off).
4.
Section Turn On
This setting is the number of seconds that the system will
anticipate when turning section valves on. Default is .2
seconds.
5.
Section Turn Off
This setting is the number of seconds that the system will
anticipate when turning section valves off. Default is .2
seconds.
6.
Reference to Center Distance
This measurement defines the distance from the
reference point as specified in Configuration B to the
center of the implement itself. If the center of the toolbar
was specified as the reference point, then these values
may remain at 0.
7.
Forward (+) / Backward (-)
Measure the forward or backward distance from the Task
Controller Reference Point to the center of the implement.
HYP1100 (04-08-21)
8.
Right (+) / Left (-)
Measure the right or left distance from the Task controller
Reference Point to the center of the implement. If the
implement has no offset, leave value at 0.
9.
Activity
Choose your implement activity from the given categories.
This selection describes the controlled implement
activity to the ISOBUS network, which is typically "Crop
Protection." The default selection is "Unknown".
ACTIVITY
Unknown
Fertilizing
Sowing/Planting
Crop Protection
Tillage
Baling
Mowing
Wrapping
Harvesting
Forage Harvesting
27
Advertisement
Table of Contents
