Table of Contents
Advertisement
CONTROL OVERVIEW
TOTALS
This is the Totals screen for the ProStop-E ISOBUS rate
controller. It can also be used as an operating screen, if
desired.
1.
Totals Tabs
There are 3 independent sets of Totals counters
separated into the 2 channels. The highlighted tab
indicates which counter set is shown. Counters do
not accumulate data when system is in HOLD or when
sections are turned off.
2.
Ch. 1 Volume Counter
Displays the total volume of product applied in gallons.
The current default unit of measure is shown at right
side.
3.
Ch. 1 Area Counter
Displays the running total of total area worked in acres..
The current default unit of measure is shown at right
side.
4.
Ch. 1 Distance Counter
Displays cumulative distance traveled in feet.
5.
Ch. 1 Operating Time
Displays the cumulative running time of the system.
6.
Ch. 1 Totals Reset
Clears the counter of information (after the confirmation
screen). Reset only applies to the Tab that is currently
shown.
7.
Ch. 2 Volume Counter
Displays the total volume of product applied in gallons.
The current default unit of measure is shown at right
side.
8.
Ch. 2 Area Counter
Displays the running total of total area worked in acres.
The current default unit of measure is shown at right
side.
16
1
2
3
4
5
7
8
11
9
10
12
14
16
17
6
18
19
11
20
21
13
15
9.
Ch. 2 Distance Counter
Displays cumulative distance traveled in feet.
10. Ch. 2 Operating Time
Displays the cumulative running time of the system.
11. Ch. 2 Totals Reset
Clears the counter of information (after the confirmation
screen).Reset only applies to the tab that is currently
shown.
12. Ch. 1 Tank Refill - Current
Enter current amount of water in tank, edit to match
implement tank.
13. Ch. 1 Tank Refill - Capacity
Enter the total volume the implement tank can hold.
14. Ch. 2 Tank Refill - Current
Enter current amount of water in tank, edit to match
implement tank.
15. Ch. 2 Tank Refill - Capacity
Enter the total volume the implement tank can hold.
16. Home
This softkey directly navigates to the Totals screen.
17. Configure
This softkey directly navigates to the Configure screen.
18. Ch. 1 Auto/Manual
This softkey selects Automatic or Manual control.
19. Ch. 2 Auto/Manual
This softkey selects Automatic or Manual control.
20. Run/Hold
This softkey controls Run/Hold (application on/off).
21. Alarm Mute
This softkey controls the audible alarm mute. When
engaged, audible alarms are turned off.
HYP1100 (04-08-21)
Advertisement
Table of Contents
