Pentair PROSTOP-E Installation And Operation Manual page 15

Table of Contents

Advertisement

CONTROL OVERVIEW
10. Tank Level
This display shows the calculated amount of liquid
remaining in the tank. The red line shows the approximate
value of the Tank Alarm. (To enter tank information at
refill, see Totals screen, on following page.
11. Multifunction Outputs
These indicators (not shown) appear in the area shown
above when the system Multifunction Outputs are active.
The default setting for both outputs is Master. This value
can be accessed in Ch.1 Setup/Outputs.
12. Speed
This displays vehicle speed. The speed source for
the system is defaulted to Remote to access speed
information from the ISOBUS network. The label on the
Speed window shows the source of the speed signal
- Blended, GPS, Wheel, or Ground (radar). The setting
for speed source is located in Configuration/Tab A. To
connect an alternate speed source directly to the wiring
harness, choose Local in Configuration Tab A - Speed
Source.
13. Task Controller Connect
This button will connect the ProStop-E ISOBUS system
to the Task Controller on the network. Task Controller
parameters in Configuration-tab B, and Channel Setup-
Implement tab MUST be measured and entered before
attachment. Changing those parameters is NOT possible
once the Prostop-E ISOBUS system is attached.
14. Totals
This softkey directly navigates to the Totals screen.
15. Configure
This softkey directly navigates to the Configure screen.
16. Auto/Manual
This softkey selects Automatic or Manual control of
application.
17. Run/Hold
This softkey controls Run/Hold (application on/off) for
entire system.
18. Alarm Mute
This softkey controls the audible alarm mute. When
engaged, audible alarms are turned off.
19. Fence Nozzle Indicators
These icons will appear if the fence nozzle option has
been enabled. This setting is located in Ch. 1 Setup/
Implement tab.
Note: If more than one liquid system will be controlled
with the ProStop-E ISOBUS rate controller, channel 2 can
be enabled by checking the "Enable Channel" button in
the CH2 Setup screen.
HYP1100 (04-08-21)
15

Advertisement

Table of Contents
loading

Table of Contents