Table of Contents
Advertisement
CONTROL OVERVIEW
CONFIGURATION B
1
2
3
4
5
6
7
8
9
1.
Implement Switch - Run=Switch
Selects polarity for remote implement switch connection
- reverses circuit function. The default setting is closed,
meaning that the system will be in Hold when the circuit
is closed.
2.
Implement Switch - External Source
The default setting for External Source is Local Only. If
an Implement Switch is available on the ISOBUS network,
the input box will be accessible.
3.
ISOBUS Master
Allows for use with a master switch to control the system
on/off. Note this has a default setting of "disabled."
4.
Auto Attach Task Controller
This check box tells the system to automatically connect
to the available task controller upon startup. The Task
Controller parameters in Configuration-tab B, and
Channel Setup-Implement tab MUST be measured and
entered before attachment. Changing those parameters
is NOT possible once the system is connected.
5.
Enable Section Control
This allows the Task Controller to control section on/off.
Default setting is ON.
6.
Hitch to Reference Distance
These parameters establish a Reference Point for the
Task Controller to measure from for accurate position
calculations. Choose a reference point that is convenient,
preferably the center of the axle (or toolbar). The
remaining distance from this reference point to the first
point of application will be entered in Channel 1 setup.
See illustration at right.
18
7.
Forward (+) / Backward (-)
Measure the forward or backward distance from the hitch
to the Task Controller Reference Point.
8.
Right (+) / Left (-)
Measure the right or left distance from the hitch to the
Task Controller Reference Point. If the implement has no
offset, leave value at 0.
9.
Hitch Type
Choose your hitch type. This choice allows the system to
process in-field calculations more accurately.
HYP1100 (04-08-21)
Advertisement
Table of Contents
