Menus And Functions; General Functions; Switching On; Switching Off - Cleco CellCore CCBA Programming Manual

3

Menus and Functions

3.1

General functions

3.1.1

Switching on

To switch on the tool, press the Start switch.
3.1.2

Switching off

There are several ways to switch off the tool.
Option 1:
Remove the battery.
→ Tool switches off after 20 seconds.
Option 2:
1. Navigate to Switching the tool off:
2. Press the
→ The
→ After five seconds, the tool switches off.
Option 3:
The tool will switch off if it is not used for a certain time. See 3.7.4 Setting the shut-off properties, page 27.
3.1.3

Selecting a button

When talking about pressing a button in this manual, this means the following:
1. Use the arrow buttons to navigate to the desired button (outlined in blue).
2. Press the
3.1.4

Changing parameters

1. Press the
2. Change the number using the arrow buttons.
3. Confirm with the
3.1.5

Change between FastApps/mPro mode

1. Select
2. Press the
FastApps mode is activated.
mPro mode is activated. A connection to the controller is necessary, see document P2402KA.
Apex Tool Group
>
button.
symbol is displayed on the LCD.
button.
button.
button.
> > .
button to switch between modes:
P2398PM | 2019-12
>
3
Menus and Functions
EN
9