Cleco CellCore CCBA Programming Manual page 6

1
About this Description
EN
Warnings and notices
Warning notices are identified by a signal word and a pictogram:
• The signal word describes the severity and the probability of the impending danger.
• The pictogram describes the type of danger
Danger
A symbol combined with the word Danger indicates a hazard with a high level of risk which, if not avoided,
will result in death or extremely serious injuries.
Warning
A symbol combined with the word Warning indicates a hazard with a medium level of risk which, if not
avoided, could result in death or serious injury.
Caution
A symbol combined with the word Caution indicates a hazard with a low level of risk which, if not avoided,
could result in minor or moderate injuries or environmental damage.
Note
A symbol combined with the word Note indicates a potentially harmful situation which, if not avoided,
could result in damage to the tool or the
General instructions include application tips and useful information, but no warnings against hazards.
Abbreviations
Abbreviation
OK
TQ
NOK
AN
Definition
Term
FastApps mode
mPro mode
6
environment.
Description
Result is OK
Torque
Result is not in order
Angle
Description
In the FastApps mode, the tool works independently without a controller.
The Linking groups (FastApps) and settings are parameterized on the tool.
In the mPro mode, a connection between the tool and the controller is nec-
essary. The linking group and settings are parameterized on the controller
and sent to the tool.
P2398PM | 2019-12
Apex Tool Group