Installing And Wiring Pg Speed Control Cards - YASKAWA VARISPEED-616G5 Instruction Manual

Wiring
3.7.1 Installing a PG Speed Control Card

3.7 Installing and Wiring PG Speed Control Cards

3.7.1 Installing a PG Speed Control Card
3
PG Speed Control Cards are used for executing speed control using a pulse generator (PG). There are four types
of PG speed control, as shown below. Select the type that fits the application and control method.
PG-A2
A-phase (single) pulse input for open collector output or complementary outputs, for V/f control
PG-B2
A/B-phase pulse input for open collector output or complementary outputs, for vector control
PG-D2
A-phase (single) pulse input for line driver input, for V/f control
PG-X2
A/B/Z-phase pulse input for line driver input, for vector control
Use the following procedure to install a PG Speed Control Card.
1. Turn off the main-circuit power supply.
2. Leave it off for at least one minute before removing the front cover of the Inverter (or at least three
minutes for Inverters of 30 kW or more). Check to be sure that the CHARGE indicator is OFF.
3. Insert the spacer (which is provided) into the spacer hole in the Inverter's mounting base.
For Inverters of 3.7 kW or lower, there are two adjacent holes. Insert the spacer into the 7CN hole. The
spacer cannot be easily removed if inserted into the wrong hole. Be very careful to insert the spacer
into the correct hole, and in the proper direction.
4. Referring to the enlarged illustration in the following diagram, align the PG Speed Control Card with
the catch position as shown by (a) and (b) and fit it precisely to the Option-A connector. Insert at (a)
first.
5. Pass the spacer through the spacer hole at the Card. (Refer to A in the illustration.) Check to be sure
that it is precisely aligned with the 4CN position, and snap it into the proper position. Be sure to press
it in firmly until you hear it snap into place.
PG Speed Control Card Spacer mounting hole
4CN
Option-A
Connector
2CN
Option-C
Connector
3CN
Option-D
Connector
Connection
terminals
Ground terminal 12
[Front]
Fig 3.22 Installing a PG Speed Control Card
Option A
Top
7CN
Option C
PG Speed
Control
Control
board
Card
Option D
(b)
(a)
Bottom
Enlargement
3 - 24
Option A mounting spacer
(Accessory: SRNT41028-9)
Inverter mounting base
Inverter
mounting base
Control board
Mounting
base side
Option A side
Spacer mounting
[Side]
Spacer mounting
hole
Spacer