Wiring The Control Circuit - YASKAWA VS MINI J7 Series Instruction Manual

All manuals and user guides at all-guides.com

• Wiring the Control Circuit

Only basic insulation is provided for the control circuit terminals.
Additional insulation may be necessary in the end product.
• Control Circuit terminals
Pass the cable through wiring hole and connect. Be sure to mount all the covers in the
original position.
* SW7 can be changed according to sequence input
signal (S1 to S5) polarity.
0V common: NPN side (factory setting)
24 common: PNP side
Refer to pages 89 for SW8
Wiring the control circuit terminals
Insert the wire into the lower part of the terminal block and connect it tightly with a
screwdriver.
Wire sheath strip length must be 0.22 in. (5.5mm).
Screwdriver blade width
45