Solutions When The Image Brightness Or Colors Are Incorrect; Solutions When An Afterimage Remains On The Projected Image; Solutions To Sound Problems - Epson EV-110 User Manual

Solving Image or Sound Problems
Solutions When the Image Brightness or Colors are
Incorrect
If the projected image is too dark or light, or the colors are incorrect, try the
following solutions:
• Check your video source settings.
• Adjust the available settings in the projector's Image menu for the current
input source, such as Color Mode, Brightness, Contrast, Tint, and Color
Saturation.
• Make sure you selected the correct Video Range setting in the projector's
Signal menu, if available for your image source.
Signal > Advanced > Video Range
s
• Make sure all the cables are securely connected to the projector and your
video device. If you connected long cables, try connecting shorter cables.
• Make sure Brightness Settings are set correctly.
Settings > Brightness Settings
s
• Position the projector close enough to the screen.
• When using multiple projectors, make sure Light Source Calibration in the
Reset menu is set correctly in all of the projectors. If light source calibration
is performed only in some of the projectors, the white balance and the
brightness level of the projected image may differ between the projectors.
g g Related Links
• "Adjusting Image Quality (Color Mode)"
• "Input Signal Settings - Signal Menu"
• "Image Quality Settings - Image Menu"
• "Projector Feature Settings - Settings Menu"
• "Projector Reset Options - Reset Menu"
Solutions When an Afterimage Remains on the
Projected Image
If you see an afterimage in the projected image, use the Refresh Mode feature
to clear it. Select Refresh Mode > Start in the projector's Reset menu.
p.51
p.123
p.122
p.124
p.139
g g Related Links
• "Projector Reset Options - Reset Menu"

Solutions to Sound Problems

If there is no sound or the volume is too low or high, try the following
solutions:
• Adjust the projector's volume settings.
• Press the [A/V Mute] button on the remote control to resume video and
audio if they were temporarily stopped.
• Check your computer or video source to make sure the volume is turned up
and the audio output is set for the correct source.
• Check the audio cable connections between the projector and your video
source.
• Make sure any connected audio cables are labeled "No Resistance".
• If you do not hear sound from an HDMI source, set the connected device to
PCM output.
• When you are connecting the projector to a Mac using an HDMI cable,
make sure your Mac supports audio through the HDMI port.
• If the volume for the computer is set to the minimum while the projector is
set to the maximum, the noise may be mixed. Turn up the computer's
volume and turn down the projector's volume. (When you use Epson
iProjection (Windows/Mac).)
g g Related Links
• "Projector Connections" p.24
• "Projector Setup Settings - Extended Menu"
• "Controlling the Volume with the Volume Buttons"
154
p.139
p.126
p.56