Projector Placement - Epson EV-110 User Manual

Projector Placement

Use the mount supplied to install the projector on a wall or ceiling.
Optional mounts are necessary to install the projector on lighting tracks or to
install it on the floor or a table.
Note the following points when selecting a projector location:
• Place the projector on a sturdy, level surface or install it using a compatible
mount.
• Leave plenty of space around and under the projector for ventilation, and
do not place it on top of or next to anything that could block the vents.
Warning
• Do not use or install the projector where it may be subject to water or rain, or
high humidity, such as outdoors, in a bathroom, or shower room, and so on.
Otherwise, it could cause a fire or electric shock.
• A special method of installation is required when installing the projector on a
wall or ceiling. Contact a qualified technician to install the projector. If you do
not install the projector correctly, it could fall and cause damage or injury.
• Do not use adhesives on the fixing points for the mounts to prevent the screws
from loosening, or use lubricants, oils, or similar substances on the projector; the
projector case may crack causing it to fall from its mount. This could cause
serious injury to anyone under the mount and could damage the projector.
• Failure to install the ceiling mount and projector may cause the projector to fall.
After installing the specific Epson mount that supports your projector, make
sure you secure the mount to all of the projector's ceiling mount fixing points.
Also, secure the projector and the mounts using the safety wire supplied with the
projector or an optional wire.
• Do not install the projector in a location subject to high levels of dust or
humidity, or in a location subject to smoke or steam. Otherwise, it could cause a
fire or electric shock to occur.
Warning
• When adjusting the orientation of the projection unit, make sure that the
projected light does not fall on the projector's power supply section. If projected
light falls on the projector, it may become hot causing an injury or fire to occur.
• Do not cover the projector's air intake or air exhaust vents. If the vents are
covered, the internal temperature could rise and cause a fire.
• Do not use or store the projector in locations where it will be subject to dust or
dirt. Otherwise, the quality of the projected image may decline, and it could
cause a malfunction or fire.
• Do not install the projector on an unstable surface or in a location beyond the
weight specifications of the projector. Otherwise, it could fall or topple causing
an accident and injury.
• Do not use adhesives to prevent the screws from loosening, or use lubricants,
oils, or similar substances on the ball joint. Otherwise, the strength that is
necessary to hold the projection unit in place decreases which could cause an
accident or injury to occur.
• Do not install in locations where salt damage could occur, or in locations subject
to corrosive gas such as sulphuric gas from hot springs. Otherwise, corrosion
could cause the projector to fall. It could also cause the projector to malfunction.
Caution
Make sure you install the optional Floor Stand when placing the projector on the
floor.
Attention
• If you are using the projector at altitudes above 1,500 m, set the High Altitude
Mode setting to On in the projector's menu to ensure the projector's internal
temperature is regulated properly.
s Extended > Operation > High Altitude Mode
• The cable connecting the power supply unit and the projection unit is wrapped
in plastics at the time of purchase. Make sure you remove the plastics before
using the projector.
g g Related Links
• "Notes on Transporting" p.19
• "Projector Setup and Installation Options"
18
p.19