Connecting To External Sensor Devices; Attaching And Removing The Cable Clips - Epson EV-110 User Manual

Projector Connections
• Connect a Bluetooth device that supports copyright protection
(SCMS-T).
a
• You may not be able to connect depending on the standard and type
of device.
• Even when connecting within the specified communication distance,
connections can be lost due to the status of the signal.
• The communication method for Bluetooth uses the same frequency
(2.4 GHz) as wireless LAN (IEEE802.11b/g/n) or microwave ovens.
Therefore, if these devices are used at the same time, radio wave
interference may occur, the audio may be interrupted, or
communication may not be possible. If you do need to use these
devices at the same time, make sure there is enough distance between
them and the Bluetooth device.
• When using a Bluetooth device and a wireless LAN at the same time,
use wireless LAN in the 5 GHz frequency band. If you use wireless
LAN in the 2.4 GHz frequency band, radio wave interference may
occur, the image and audio may be interrupted, or upload times may
be longer.
• You cannot connect multiple Bluetooth devices to the projector at
the same time.

Connecting to External Sensor Devices

You can connect external devices such as sensors by using a USB cable to
receive the input signal from the sensor devices. See the EV-115/EV-110
External Sensors Setup Guide for details.
You can download the information from the following Web site.
epson.sn
Attention
Incorrect connection could damage the product. Contact a qualified technician to
connect the external sensor device.
• The projector's DC Out (2.0A) / GPI In port cannot receive USB
standard signals.
a
• You need to process the sensor cable so that you can connect it to the
DC Out (2.0A) / GPI In port. Alternatively, you can use a
commercially available connector instead.
• As well as sensors, you can also connect other external devices such
as buttons and switches.
a
Connect the USB cable to your external sensor's output port.
b Connect the other end to the projector's DC Out (2.0A) / GPI In port.
g g Related Links
• "Using External Sensors" p.79

Attaching and Removing the Cable Clips

You can insert the cable clips so that the power cord and HDMI cable do not
disconnect under their own weight.
a Connect the power cord and HDMI cable to the projector.
28