Solutions When The Image Is Not Rectangular; Solutions When The Image Contains Noise Or Static; Solutions When The Image Is Fuzzy Or Blurry - Epson EV-110 User Manual

Solving Image or Sound Problems

Solutions When the Image is not Rectangular

If the projected image is not evenly rectangular, try the following solutions:
• Place the projector directly in front of the center of the screen, facing it
squarely, if possible.
• Press the [Keystone] buttons on the remote control to adjust the image
shape.
• Adjust the Quick Corner setting to correct the image shape.
Settings > Keystone > Quick Corner
s
g g Related Links
• "Correcting the Image Shape with the Keystone Button"
• "Correcting the Image Shape with Quick Corner"

Solutions When the Image Contains Noise or Static

If the projected image contains electronic interference (noise) or static, try the
following solutions:
• Check the cables connecting your computer or video source to the
projector. They should be:
• Separated from the power cord to prevent interference
• Securely connected at both ends
• Not connected to an extension cable
• Check the settings in the projector's Signal menu to make sure they match
the video source.
• Select a computer video resolution and refresh rate that are compatible with
the projector.
• If you adjusted the image shape using the projector controls, try decreasing
the Sharpness setting in the projector's Image menu to improve image
quality.
• If you connected an extension power cable, try projecting without it to see if
it caused interference in the signal.

Solutions When the Image is Fuzzy or Blurry

p.42
p.43
g g Related Links
• "Input Signal Settings - Signal Menu"
• "Image Quality Settings - Image Menu"
• "Supported Monitor Display Resolutions"
If the projected image is fuzzy or blurry, try the following solutions:
• Adjust the image focus.
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so wide that it
distorts the image.
• Clean the projector lens.
To avoid condensation on the lens after bringing the projector in
from a cold environment, let the projector warm up to room
temperature before using it.
a
• Adjust the Sharpness setting in the projector's Image menu to improve
image quality.
• If you are projecting from a computer, use a lower resolution or select a
resolution that matches the projector's native resolution.
g g Related Links
• "Input Signal Settings - Signal Menu"
• "Image Quality Settings - Image Menu"
• "Supported Monitor Display Resolutions"
• "Focusing the Image" p.47
• "Cleaning the Lens" p.144
153
p.123
p.122
p.165
p.123
p.122
p.165