Solving Projector Or Remote Control Operation Problems; Solutions To Projector Power Or Shut-Off Problems; Solutions To Problems With The Remote Control; Solutions To Password Problems - Epson EV-110 User Manual

Solving Projector or Remote Control Operation Problems

Check the solutions in these sections if you have problems operating the
projector or remote control.
g g Related Links
• "Solutions to Projector Power or Shut-Off Problems"
• "Solutions to Problems with the Remote Control"
• "Solutions to Password Problems"
• "Solution When "The Battery that Saves Your Clock Settings is Running
Low" Message Appears" p.156

Solutions to Projector Power or Shut-Off Problems

If the projector does not turn on when you press the power button or it turns
off unexpectedly, try the following solutions:
• Make sure the power cord is securely connected to the projector and to a
working electrical outlet.
• If the power button on the remote control does not turn on the projector,
check its batteries and make sure the remote receiver is turned on in the
Remote Receiver setting in the projector's Settings menu.
• If the projector's light source turns off, the status indicator is flashing, and
the temp (temperature) indicator is lit, the projector has overheated and
turned off.
• The cooling fans may run in standby status depending on the projector
settings. Also, when the projector wakes from standby status, the fans may
cause an unexpected noise. This is not a malfunction.
• The power cord may be defective. Disconnect the cord and contact Epson
for help.
g g Related Links
• "Projector Indicator Status" p.149
• "Projector Feature Settings - Settings Menu"
p.155
p.155
p.155
p.124

Solutions to Problems with the Remote Control

If the projector does not respond to remote control commands, try the
following solutions:
• Check that the remote control batteries are installed correctly and have
power. If necessary, replace the batteries.
• Make sure you are operating the remote control within the reception angle
and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to
enter sleep mode. Release the button to wake the remote control up.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be
interfering with the projector's remote receivers. Dim the lights or move the
projector away from the sun or interfering equipment.
• Make sure the remote receiver is turned on in the Remote Receiver setting
in the projector's Settings menu.
• If the Remote Receiver setting is disabled, hold down the [Menu] button on
the remote control for at least 15 seconds to reset the setting to its default.
• If you assigned an ID number to the projector to operate multiple projectors
from the remote control, you may need to check or change the ID setting.
• If you lose the remote control, you can order another one from Epson.
g g Related Links
• "Remote Control Operation" p.31
• "Projector Feature Settings - Settings Menu"
• "Selecting the Projector You want to Operate"
• "Installing Batteries in the Remote Control"

Solutions to Password Problems

If you cannot enter or remember a password, try the following solutions:
• You may have turned on password protection without first setting a
password. Try entering 0000 using the remote control.
155
p.124
p.68
p.30