CAM PULLEY/CRANKSHAFT/PISTON/
CYLINDER BLOCK
PISTON CONNECTING ROD REASSEMBLY
1. Apply oil to the piston pin, piston pin hole and the connecting
rod small end.
2. Set the piston so that the 'FW' mark stamped at the back of
the piston points down.
3. Set the connecting rod in the piston so that the model mark
(ZL8, Z8B, or Z2A) by the piston pin hole and the longer side
of the connecting rod large face to the right-hand side.
4. Apply oil to the piston pin and install it in the piston.
5. Install new piston pin clips.
6. Install the piston/connecting rod assembly in the cylinder
block
(P.
9-10).
9-8
HRS216PKA • HRS216SKA • HRS216VKA
PISTON
MODEL MARK
(ZL8, Z8B, Z2A)
PISTON PIN
PISTON PIN CLIP (2)
FW MARK
CONNECTING ROD
WITH THE LONG END