Honda HRS216PKA Manual page 82

HRS216PKA • HRS216SKA • HRS216VKA
2. FLYWHEEL REMOVAL/INSTALLATION
REMOVAL
1. Remove the fan cover/fuel tank
2. Hold the flywheel brake lever against the handlebar and
secure it there with a strap or equivalent material. This
allows the flywheel and crankshaft to turn.
3. Hold the flywheel with the special tool and a breaker bar,
and remove the 14 mm special nut with a wrench.
NOTICE
Inserting a rod or screwdriver in the fan blades can
damage the blades or the aluminum casting projections.
4. Remove the plastic cooling fan.
5. Position a commercially available 6-inch flywheel puller
on the flywheel with one of the puller jaws under the
magnets (at the PULLER mark).
Set a shop towel or equivalent cloth between the flywheel
and the puller.
6. Tighten the flywheel puller, and then tap the end of the
puller to remove the flywheel.
(P. 7-17).
FLYWHEEL / IGNITION COIL
SPECIAL NUT, 14 mm
PULLER MARK

FLYWHEEL HOLDER
07APB-Z28A100
8-3