Honda HRS216PKA Manual page 91

CAM PULLEY/CRANKSHAFT/PISTON/
CYLINDER BLOCK
THRUST WASHER INSTALLATION
1. Install the timing belt on the timing belt pulley.
2. Install the thrust washer; note the installation direction.
CYLINDER BLOCK/OIL PAN ASSEMBLY
1. Align the mark on the cylinder block with the mark on the
crankshaft.
2. Install the cam pulley
3. Clean only the mating surfaces of the cylinder block and
the oil pan using a degreasing cleaning agent or a clean
shop towel.
4. Install the two 8 x 20 mm dowel pins in the cylinder block.
5. Apply a bead 1.5 - 2.0 mm (0.06 - 0.08 in) of liquid gasket
(Hondabond HT, ThreeBond 1216, Loctite
equivalent) to the cylinder block.
6. Install the oil pan on the cylinder block.
Assemble within 10 minutes after applying the liquid
gasket.
If it is hard to install the oil pan securely, assemble by
turning the crankshaft a little.
7. Loosely tighten each 6 x 25 mm flange bolt, and then
tighten to the specified torque in the numbered sequence.
TORQUE: 12 N•m (9 ft-lb)
8. Wait for at least 20 minutes after assembly before filling it
with oil and starting the engine.
9-6
(P. 9-2).
®
5900, or
HRS216PKA • HRS216SKA • HRS216VKA
THRUST WASHER
CRANKSHAFT
CYLINDER
BLOCK
LIQUID GASKET
APPLICATION
AREA
8 x 20 mm
DOWEL PIN
TIMING BELT
MARK
MARK
CYLINDER
BLOCK
8 x 20 mm
DOWEL PIN