Honda HRS216PKA Manual page 107

HANDLE PIPE/CABLES
1. HANDLE PIPE REPLACEMENT
K5 PKA/SKA MODELS
1. Cut the cable ties securing the brake cable and drive clutch cable to the handle pipe.
2. Remove the 6 mm nylon nut, 6 x 60 mm hex bolt, and the flywheel brake cable assembly from the handle pipe
assembly.
3. Remove the flywheel brake lever from the handle pipe, then from the lever stop.
4. Remove the lever stop from the handle pipe.
5. Remove the two handle knobs and the handle pipe from the handle stays.
6. Remove the 6 mm nylon nut and the rope guide.
7. Install the handle pipe in the reverse order of its removal.
ROPE GUIDE
HANDLE PIPE
HANDLE KNOB (2)
8 x 16 mm
FLANGE BOLT
8 mm FLANGE NUT (6)
HANDLE STAY (2)
FLYWHEEL BRAKE
CONTROL CABLE
DRIVE CLUTCH CABLE (SKA)
10-2
HRS216PKA • HRS216SKA • HRS216VKA
LEVER STOP
6 mm
NYLON NUT
CABLE TIE (2)
6 mm NYLON NUT
8 mm PIN (2)
CLUTCH LEVER (SKA)
FLYWHEEL
BRAKE LEVER
6 x 60 mm
HEX BOLT