Honda HRS216PKA Manual page 112

HRS216PKA • HRS216SKA • HRS216VKA
K6 PKA MODEL
This procedure explains the removal and installation for both
left and right handle stays. If only replacing one handle stay,
follow the instructions for only that side.
1. Release the handlebar locking knobs and fold the
handle pipe assembly over the top of the mower in the
storage/transportation position.
2. Remove the two special bolts and nylon washers
release the handle pipe assembly from the handle
stays.
3. Remove the rear scroll by loosing the four 8 mm flange
.
nuts (P. 11-2).
4. Remove the wheel bolt, wheel, wheel washer, and
flat washer from each side.
5. Remove the 25 mm circlip and the 26 x 36 mm
washers from each side.
HANDLE PIPE/CABLES
HANDLE STAY
(left side shown)
FLAT WASHER
WHEEL WASHER
ADJUSTER
ASSEMBLY
26 x 36 mm
WASHER
25 mm
CIRCLIP
NYLON WASHER (2)
SPECIAL
BOLT (2)
HANDLE
LOCKING
KNOB (2)
WHEEL
BOLT
10-7