Honda HRS216PKA Manual page 108

HRS216PKA • HRS216SKA • HRS216VKA
K6 PKA MODEL
1. Cut the cable ties securing the brake cable to the handle pipe.
2. Remove the 6 mm locking nut, 6 x 45 mm flange bolt, 6 mm plain washer, and the flywheel brake cable
assembly from the handle pipe assembly.
3. Remove the flywheel brake lever from the handle pipe, then from the lever stop.
4. Remove the lock pin; then remove the lever stop from the handle pipe.
5. Remove the starter rope from the rope guide, and then remove the 6 mm locking nut and the rope guide.
6. Remove the two special bolts, nylon washers, and the handle assembly from the handle stays.
7. Drive out the two 2 x 12 mm roll pins and remove the handle lock assemblies.
8. Install the handle pipe in the reverse order of its removal.
LEVER STOP
LOCK PIN
ROPE GUIDE
6 mm LOCKING NUT
HANDLE PIPE
HANDLE STAY (2)
REMOVAL/INSTALLATION:
8 mm PIN (2)
HEIGHT
ADJUSTING
COLLAR (2)
HEIGHT
ADJUSTING
SPRING (2)
P. 10-7
6 mm LOCKING NUT
FLYWHEEL BRAKE
CONTROL CABLE
CABLE TIE (2)
SPECIAL BOLT (2)
2 x 12 mm
ROLL PIN (2)
HANDLE LOCKING KNOB (2)
REMOVAL/INSTALLATION:
HANDLE PIPE/CABLES
6 mm PLAIN WASHER
FLYWHEEL
BRAKE LEVER
6 x 45 mm
FLANGE BOLT
NYLON WASHER (2)
(P. 10-12)
10-3