Muffler - Honda HRS216PKA Manual

1. REMOVAL/INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. REMOVAL/INSTALLATION
 CAUTION
The engine and muffler become very hot during operation, and
they remain hot for a while after operation.
A hot engine or muffler can burn you.
Be sure that the engine is cold before muffler removal/installation.
SPARK ARRESTER (optional part)
INSTALLATION:
Install after removing the carbon from
the screen with a wire brush.
6 x 12 mm
SCREW, (3)

MUFFLER

PROTECTOR
6 x 79 mm FLANGE BOLT (2)
12 N•m (9 ft-lb)
4 x 6 mm
SELF-TAPPING SCREW
(optional part)
SPARK ARRESTER
IDENTIFICATION PLATE
(optional part)
MUFFLER
INSTALLATION:
• Use a plastic hammer to loosen carbon deposits from
the muffler, and then remove carbon deposits from
muffler.
• Do not tap on the muffler seal flange to avoid damaging
this part. If the seal flange is dented or damaged, replace
the muffler.
• Check the cylinder exhaust port for damage, and install
muffler.
MUFFLER SEAL
FLANGE
5. MUFFLER
MUFFLER GASKET
(optional part)
Install a gasket anytime the
muffler has been removed.
EXHAUST PORT
.5-1
5-1