Honda HRS216PKA Manual page 101

CAM PULLEY/CRANKSHAFT/PISTON/
CYLINDER BLOCK
PISTON RING SIDE CLEARANCE INSPECTION
Top ring 0.055 ~ 0.089 mm
(0.002 ~ 0.004 in)
Second ring 0.015 ~ 0.049 mm
(0.0006 ~ 0.0019 in)
PISTON RING END GAP INSPECTION
Use the top of the piston to position the ring horizontally in the
cylinder. When replacing the rings, do not hone the cylinder.
Top ring 0.20 ~ 0.35 mm
(0.008 ~ 0.014 in)
Second ring 0.35 ~ 0.50 mm
(0.014 ~ 0.020 in)
Oil ring 0.20 ~ 0.70 mm
(0.008 ~ 0.030 in)
PISTON PIN O.D. INSPECTION
Standard
13.000 mm (0.5118 in) 12.954 mm (0.5100 in)
PISTON PIN BORE I.D. INSPECTION
Standard
13.002 mm (0.5119 in)
9-16
Standard Service limit
0.150 mm
(0.006 in)
0.150 mm
(0.006 in)
Standard Service limit
1.00 mm
(0.040 in)
1.00 mm
(0.040 in)
1.00 mm
(0.040 in)
Service limit
Service limit
13.048 mm (0.5137 in)
HRS216PKA • HRS216SKA • HRS216VKA