HANDLE PIPE/CABLES
2. HANDLE STAY REMOVAL
K5 PKA AND SKA MODELS
1. Release the handlebar locking knobs and allow the
handle pipe assembly to rest on the floor.
2. Remove the two special bolts and nylon washers,
and remove the handle pipe assembly from the
handle stays.
3. Remove the rear scroll
4. Move the rear adjusting lever all the way forward.
5. Remove the three 8 mm flange nuts and the left
handle stay.
6. Remove the three 8 mm flange nuts and the right
handle stay.
Installation is the reverse of removal.
10-6
(P.
11-2).
HRS216PKA • HRS216SKA • HRS216VKA
HANDLE STAY
(left side shown)
REAR
ADJUSTING
LEVER
8 mm
FLANGE
NUT (3)
RIGHT
HANDLE
STAY
NYLON WASHER (2)
HANDLE PIPE
ASSEMBLY
SPECIAL
BOLT (2)
HANDLE LOCKING
KNOB (2)
LEFT
HANDLE
STAY
8 mm
FLANGE
NUT (3)