Fuel System - Honda HRS216PKA Manual

1. AIR CLEANER/CARBURETOR
REMOVAL/INSTALLATION . . . . . . . . . . . .
2. CARBURETOR
DISASSEMBLY/REASSEMBLY. . . . . . . . .
3. CARBURETOR CLEANING. . . . . . . . . . . .
1. AIR CLEANER/CARBURETOR REMOVAL/INSTALLATION
NOTICE
If the carburetor is removed before the engine has completely cooled, the thermowax plunger may still be extended. The plunger
will not retract when the thermowax assembly is allowed to cool after removal without a continuous force applied (see
Before removing the carburetor, allow the engine to cool long enough for the choke to completely close. This typically requires
about 20 minutes.
 WARNING
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
• Stop the engine and let it cool before handling fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
1. Turn the fuel valve to the OFF position.
2. Completely drain the carburetor
3. Remove the air cleaner cover and air filter.
4. Remove one 6 x 85 mm flange bolt securing the air cleaner case, and temporarily replace it with a 6 x 83 mm
stud. Install and hand-tighten the stud.
5. While pushing the air cleaner case toward the engine, remove the other 6 x 85 mm flange bolt, and temporarily
install another 6 x 83 mm stud.
AIR CLEANER CASE
6. Pull the breather tube from the engine, and then remove the air cleaner case from the studs.
7. Hold the carburetor assembly together and remove it from the studs.
7-1
7-3
7-4
(page 3-9).
6 x 83 mm STUD (2)
Temporarily installed.
P/N 90013-ZG9-T00

7. FUEL SYSTEM

4. FUEL VALVE/GOVERNOR ARM. . . . . . .
5. FAN COVER/FUEL TANK . . . . . . . . . . . .
6. EVAPORATIVE EMISSION CONTROL
SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . .
FUEL VALVE
6 x 85 mm SPECIAL
BOLT (2)
AIR FILTER
7-16
7-17
7-19
page 7-14).
AIR CLEANER
COVER
7-1