Honda HRS216PKA Manual page 135

TRANSMISSION / DRIVE BELT
10. Remove the rear scroll by removing the four 8 mm
flange bolts and two 8 mm flange nuts.
11. Push down on the transmission control arm as
shown, and disconnect the Smart Drive cable end
from the transmission control arm.
12. Remove the belt tension spring from the cable
holder and the transmission control arm.
13. Hold the end of the transmission input shaft with an
adjustable wrench, and then remove the 10 mm
flange nut.
14. Remove the driven pulley, 10 mm washer, and the
V-belt from the transmission.
12-4
HRS216PKA • HRS216SKA • HRS216VKA
SMART DRIVE
CABLE END
CABLE HOLDER
INPUT SHAFT
FLANGE NUT
10 mm
8 mm
FLANGE
BOLT (4)
REAR SCROLL
8 mm
FLANGE
NUT (2)
Push on the transmission control
arm in the direction shown.
TRANSMISSION
CONTROL ARM
BELT TENSION
SPRING