Honda HRS216PKA Manual page 61

FUEL SYSTEM
8. Remove the throttle return spring from the carburetor throttle lever.
9. Rotate the carburetor in the direction shown, and remove the governor rod from the carburetor throttle lever.
The insulator, air guide, and gaskets do not need to be removed unless the gaskets are damaged and need to
be replaced.
10. Reinstall in the reverse order from removal.
GOVERNOR ROD/THROTTLE RETURN SPRING
REMOVAL:
Remove the throttle return spring, and then rotate the carburetor in the direction
shown and remove the governor rod from the carburetor.
THROTTLE RETURN SPRING
P. 7-16
INSTALLATION:
THERMOWAX ASSEMBLY
Apply a small amount of
Hondabond HT to the
bottom and lower third of
the new thermowax. Do not
apply too much.
REMOVAL:P. 7-14
INSULATOR
GASKET
Replace.
CHOKE CONTROL ASSEMBLY
P. 2-22
TROUBLESHOOTING:
P. 2-22
INSTALLATION:
CARBURETOR
DISASSEMBLY/REASSEMBLY:
P. 7-3
P. 7-4
CLEANING:
P. 7-13
INSPECTION:
CRANKCASE BREATHER TUBE
P. 7-15
INSTALLATION:
7-2
GOVERNOR ROD
INSTALLATION:
AIR GUIDE
GASKET
Replace.
HRS216PKA • HRS216SKA • HRS216VKA
P. 7-16
GOVERNOR SPRING
INSTALLATION:
AIR CLEANER
GASKET
Replace.
Be sure to install
the gasket so the
hole aligns with the
carburetor vent float
chamber.
AIR
CLEANER
CASE
P. 7-16
FUEL VALVE ASSEMBLY
B12 TUBE CLIP (2)
6 x 14 mm
FLANGE BOLT
6 x 14 mm
FLANGE BOLT
B8 TUBE CLIP (2)